[Tinyos-help] CURRENT ABSORPTION ON THE EXPANSION CONNECTORS ADCWITH TINYOS -2.x

[André Miguel de Almeida Marrão Rodrigues]

What was the state of the serial port on the usb connector? Are you using printf?


  ----- Original Message ----- 
  From: Kevin Klues 
  To: Roberto Vittorio 
  Cc: tinyos-help 
  Sent: Sunday, December 16, 2007 12:35 AM
  Subject: Re: [Tinyos-help] CURRENT ABSORPTION ON THE EXPANSION CONNECTORS ADCWITH TINYOS -2.x


  This sounds discouraging.  What was your test setup exactly?

  Kevin


  On Dec 14, 2007 7:56 AM, Roberto Vittorio <new84 at libero.it> wrote:

    Hello all, the question is: if I install on Telosb the BlinkC component or any other program running on Tinyos-2.x, I see a current absorption on the expansion connectors (channel ADC0, ADC1 ADC2 ADC3) about of 7-10 mA . Instead if install the same component on Tinyos-1.x, the current equals 0 mA. What's happening with Tinyos 2.x? I suspect that the ADC are sets in output or something similar. Thanks in advance, Roberto


    _______________________________________________ 
    Tinyos-help mailing list
    Tinyos-help at millennium.berkeley.edu
    https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help




  -- 
  ~Kevin 


------------------------------------------------------------------------------


  _______________________________________________
  Tinyos-help mailing list
  Tinyos-help at millennium.berkeley.edu
  https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.millennium.berkeley.edu/pipermail/tinyos-help/attachments/20071216/03cefbc7/attachment.html