[Tinyos-help] (no subject)

[Michael Schippling]

I'm cc'ing this back to the help-list because I don't use T2 and can't help...
MS

Таня и Руслан Валовые wrote:
> In the project ..tinyos-2.x\apps\tests\storage\Block\randrwappc
> (for mica2) Atmega128 works with AT45DB without usage Atmega128's USART1 controler (the program control is used).
> How to use Atmega128's USART1 controler in this design?
> 
> -----Original Message-----
> From: Michael Schippling <schip at santafe.edu>
> To: Таня и Руслан Валовые <ruslantanya at mail.ru>
> Date: Thu, 20 Dec 2007 12:15:43 -0700
> Subject: Re: [Tinyos-help] (no subject)
> 
>> start by reading the doc/tutorial
>> then read through any code that has UART in it's name
>> in the relevant platform directories.
>>
>> MS
>>
>> Таня и Руслан Валовые wrote:
>>> Hello!
>>>
>>> I do not know as to configure system so that it used hardware controllers Atmega128
>>> For example controller UART1.
>>> To default operational systems in the program way operates bus UART1.
>>>
>>> With the best regards, Valovoi Ruslan!
>>>
>>>
>>> _______________________________________________
>>> Tinyos-help mailing list
>>> Tinyos-help at millennium.berkeley.edu
>>> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
>> -- 
>> Platform: WinXP/Cygwin
>> TinyOS version: 1.x, Boomerang
>> Programmer: MIB510
>> Device(s): Mica2, MicaZ, Tmote
>> Sensor board: homebrew
>>

-- 
Platform: WinXP/Cygwin
TinyOS version: 1.x, Boomerang
Programmer: MIB510
Device(s): Mica2, MicaZ, Tmote
Sensor board: homebrew