[Tinyos-help] Problems with Moteview 1.4 and MEP-SYS of CrossbowInc.

[Juan Antonio López Riquelme]

Hello Giri,

more thank for your reply.

Best regards,
Juan Antonio.


2007/6/18, Giri Baleri <mbaleri at xbow.com>:
>
>  Hello Juan,
>
> The MEP nodes in the MEP-SYS are programmed with XMesh 1.2 firmware and
> the low power version of this app doesn't support the commands (eg.
> change data rates). You need to reprogram the MEP nodes with the newer MEP
> application firmware available in MoteWorks to change the data rate etc.
>
>
> Regards,
> Giri Baleri
> Crossbow Technology, Inc
>
>  ------------------------------
> *From:* tinyos-help-bounces at Millennium.Berkeley.EDU [mailto:
> tinyos-help-bounces at Millennium.Berkeley.EDU] *On Behalf Of *Juan Antonio
> López Riquelme
> *Sent:* Monday, June 18, 2007 11:33 AM
> *To:* tinyos-help
> *Subject:* [Tinyos-help] Problems with Moteview 1.4 and MEP-SYS of
> CrossbowInc.
>
>
>   Hi,
>
> I am using MEP-SYS and Moteview 1.4c from Crossbow Inc (
> http://www.xbow.com/Products/productdetails.aspx?sid=245). I tried
> to change the LEDs status of only MEP410 nodes  and the sample rate in all
> nodes (MEP410 and MEP510) using the option command in tab control. After
> this, I don't see any changes in the leds and data change with the same
> sample rate that there was before changing in the option data of tab
> control.
>
> Can anyone give any advice to solve this problem?
>
> PD. I received all nodes pre-programmed.
>
> thanks in advance
>
> greetings
> Juan Antonio.
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mail.millennium.berkeley.edu/pipermail/tinyos-help/attachments/20070619/a81eee71/attachment.htm