[Tinyos-help] about CC2420

[roberto pagliari]

right, I just remembered that point in the cc2420 datasheet. I have a last
question: the transmission of a packet is performed if the RSSI value is
greater than a certain threshold, the CCA. The 3 CCA modes are

0 reserved
1 clear channel when received energy is below threshold
2 clear channel when not receiving valid IEEE data
3 clear channel when not receiving valid IEEE data and below threshold

I guess the CCA value is a 8 bit unsigned integer 2 complement, so if I need
to transmit a packet, regardless of other transmitting nod I should set the
CCA value to its minimum, lilke -128dBm, or 0xFF. I know during the
reception of a packet the RSSI is averaged over 8 symbols after the SFD has
been detected. During the transmission how does is it calculated? Can I read
it just using the command call function c.. HPLCC2420.read(RSSI_REG)?


On 6/19/07, David Moss <dmm at rincon.com> wrote:
>
>  The default mode for the radio is Rx mode – after it transmits a packet,
> it automatically switches back to Rx on the hardware.
>
>
>
> If you attempt to transmit using STXON without clear channel assessments,
> then your radio will not only **not** receive the other transmitter's
> packet, but it will cause channel interference that will prevent all other
> motes in the area from receiving that packet.  That's the point of backoffs
> and CCA (clear channel assessment) – determine if the channel is clear
> before attempting a transmission.
>
>  -David
>
>
>
>
>
>
>  ------------------------------
>
> *From:* tinyos-help-bounces at Millennium.Berkeley.EDU [mailto:
> tinyos-help-bounces at Millennium.Berkeley.EDU] *On Behalf Of *roberto
> pagliari
> *Sent:* Tuesday, June 19, 2007 3:24 PM
> *To:* tinyos-help at Millennium.Berkeley.EDU
> *Subject:* [Tinyos-help] about CC2420
>
>
>
> hi all,
> within RadioControlM I can see CC2420Control.RxMode(), but, after a packet
> has been sent I cant find any call to CC2420.RxMode() or SXON oscillator.
> where is it done?
>
> the second question is: once the transmitter oscillator STXON has been
> enabled, if an incoming message arrives, will it be lost?
>
>
> thank you
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mail.millennium.berkeley.edu/pipermail/tinyos-help/attachments/20070619/d032316d/attachment.html