[Tinyos-help] Problems with Moteview 1.4 and MEP-SYS of CrossbowInc.

[Juan Antonio López Riquelme]

Hello Giri,

I readed user's manual of MoteConfig for program the new firmware in nodes.
By the moment i only can the firmware of gateway with the version of high
power in folder mica (C:\Archivos de
programa\Crossbow\MoteView\xmesh\mica2\433MHZ\XMeshBase). RF power 255,
channel 00, in fuse setting external ocillator on option active and in
address and radio defaults firmware scan.

Now i not get data of gateway of the other nodes in MoteView. Gateway appear
disconnect. The last line in console is Hearbeat received.....

I readed in manual: "*NOTE: **OTAP *is currently available only when
*the*Motes are programmed with a high power firmware application(
i.e. XMTS310CB_433_hp.exe*).**"*
And in your before reply you said to me that nodes have a low power version,
then i not can program the nodes. I think that for programming i must
connect directly in serial port, but where connect the wire???

I wait that someone can help me.

Thanks in advance.

Best regards,
Juan Antonio.



2007/6/19, Juan Antonio López Riquelme <ja.lopez.riquelme at gmail.com>:
>
> Hello Giri,
>
> more thank for your reply.
>
> Best regards,
> Juan Antonio.
>
>
> 2007/6/18, Giri Baleri <mbaleri at xbow.com>:
> >
> >  Hello Juan,
> >
> > The MEP nodes in the MEP-SYS are programmed with XMesh 1.2 firmware and
> > the low power version of this app doesn't support the commands (eg.
> > change data rates). You need to reprogram the MEP nodes with the newer
> > MEP application firmware available in MoteWorks to change the data rate etc.
> >
> >
> > Regards,
> > Giri Baleri
> > Crossbow Technology, Inc
> >
> >  ------------------------------
> > *From:* tinyos-help-bounces at Millennium.Berkeley.EDU [mailto:
> > tinyos-help-bounces at Millennium.Berkeley.EDU] *On Behalf Of *Juan Antonio
> > López Riquelme
> > *Sent:* Monday, June 18, 2007 11:33 AM
> > *To:* tinyos-help
> > *Subject:* [Tinyos-help] Problems with Moteview 1.4 and MEP-SYS of
> > CrossbowInc.
> >
> >
> >   Hi,
> >
> > I am using MEP-SYS and Moteview 1.4c from Crossbow Inc (http://www.xbow.com/Products/productdetails.aspx?sid=245).
> > I tried to change the LEDs status of only MEP410 nodes  and the sample rate
> > in all nodes (MEP410 and MEP510) using the option command in tab control.
> > After this, I don't see any changes in the leds and data change with the
> > same sample rate that there was before changing in the option data of tab
> > control.
> >
> > Can anyone give any advice to solve this problem?
> >
> > PD. I received all nodes pre-programmed.
> >
> > thanks in advance
> >
> > greetings
> > Juan Antonio.
> >
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mail.millennium.berkeley.edu/pipermail/tinyos-help/attachments/20070621/60938658/attachment-0001.htm