[Tinyos-help] MIB600 115200

[Giri Baleri]

If you know the IP address, you can look it up in Lantronix device
installer and make a note of the corresponding MAC address.

Giri

-----Original Message-----
From: Bernardo Avila Pires [mailto:obernardo at gmail.com] 
Sent: Tuesday, October 02, 2007 12:15 PM
To: Giri Baleri
Cc: JeongKwanhee; tinyos-help at millennium.berkeley.edu
Subject: Re: [Tinyos-help] MIB600 115200

Talking about MIB600, dos anyone know how to find out the MAC address of
one of these? There's one here whose address has faded from the board.

2007/10/2, Giri Baleri <mbaleri at xbow.com>:
>
>
> Here's what you need to do to change the default baud rates for the
MIB600.
>
> 1. Open a web browser and type the IP address of MIB600. You should 
> see Lantronix web manager page.
> 2. From the left hand menu corner, click on Channel 1 and and the 
> default settings should be:
>     Serial Port Speed: 115200
>     Port :10001
>
> 3. From the left hand menu corner, click on Channel 2 and the default 
> settings should be:
>     Serial Port Speed: 57600
>     Port:10002
>
> 4. If you make changes above, save/update the settings.
>
> I hope that helps,
> Giri
>
>  ________________________________
>  From: tinyos-help-bounces at Millennium.Berkeley.EDU
> [mailto:tinyos-help-bounces at Millennium.Berkeley.EDU] On Behalf Of 
> JeongKwanhee
> Sent: Tuesday, October 02, 2007 6:19 AM
> To: tinyos-help at Millennium.Berkeley.EDU
> Subject: [Tinyos-help] MIB600 115200
>
>
>
>
>
> Hello! Everybody.
>
>
>
> I am trying to change the baud rate from 57600 to 115200 on MIB600.
>
> However, I cannot operate correctly. I do not know why it is not
running.
>
>
>
> So, I will write down about my trial for changing rate.
>
> First, I tried.
>
> In eprb.extra  file, I added -dport=10001 on uisp programming.
>
> .....is not run..
>
>
>
> Second, I tried.
>
> I changed HPLUART0M.nc file as follows.
>
> outp(15, UBRR0L) -> outp(7, UBRR0L)
>
> ...is not run..
>
>
>
> At result of my test, it always runs just to 10002 port(57600bps).
>
>
>
> If somebody know how to change the baud rate, please reply to this.
>
>
>
> Thank you
> _______________________________________________
> Tinyos-help mailing list
> Tinyos-help at Millennium.Berkeley.EDU
> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-he
> lp
>


--
"The truth shall set you free"