[Tinyos-help] Sense Application

[Ahmed Ebaid]

I'm using telosb platform, and I can modify the file, but I don't which
component I should be using in order to make my platform use the temperature
sensor, I'm running TinyOS-2.x on using XubunTOS.

On Mon, Nov 24, 2008 at 2:32 PM, Michael Schippling <schip at santafe.edu>wrote:

> You can either go into your platform directory of choice
> and change the config file for DemoSensor, or else just
> throw the whole thing out and connect directly to the ADC
> channel you want to sample. Note that the demo Temp and
> Photo sensors also need to be enabled by turning on a PWx
> pin, so the their component modules do a bit more than
> just ADC sampling.
>
> I haven't examined the MPS chip that closely but I think
> it includes an internal connection to an ADC channel to
> monitor it's supply voltage. The MPS manual is written
> in an entirely different dialect of gibberish from the
> ATMEGA and PIC ones that I'm used to, so I'm not sure.
>
> MS
>
>
> Ahmed Ebaid wrote:
>
>> Hey
>> I have a question regarding the Sense application, since the DemoSensor
>> component is a platform dependent, how can I change the configuration file
>> in order to sense temperature. also , what is the MCU-internal voltage
>> sensor do.
>> Thanks in Advance.
>>
>> --
>> Ahmed
>>
>>
>>
>>
>> ------------------------------------------------------------------------
>>
>> _______________________________________________
>> Tinyos-help mailing list
>> Tinyos-help at millennium.berkeley.edu
>> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
>>
>
> --
> Platform: WinXP/Cygwin
> TinyOS version: 1.x, Boomerang
> Programmer: MIB510
> Device(s): Mica2, MicaZ, Tmote
> Sensor board: homebrew
>
>


-- 
Ahmed Ebaid
PhD Student
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.millennium.berkeley.edu/pipermail/tinyos-help/attachments/20081124/7b9f02e3/attachment.htm