[Tinyos-help] crossbow moteconfig OTAP (for MicaZ) problem

[Giri Baleri]

Couple of things to check:

-          Make sure you have a battery voltage of at least 2.7V 

-          Make sure you have checked the boxes next to node IDs before
pressing "Prepare" button.

 

Giri

 

________________________________

From: tinyos-help-bounces at millennium.berkeley.edu
[mailto:tinyos-help-bounces at millennium.berkeley.edu] On Behalf Of MURAT
ARSLAN
Sent: Tuesday, February 17, 2009 6:20 AM
To: tinyos-help at millennium.berkeley.edu
Subject: [Tinyos-help] crossbow moteconfig OTAP (for MicaZ) problem

 

Hi to all;

I'm using crossbow's MoteConfig software for over the air programming.
The set up I am working on contains two remote motes(with MTS400 sensor
boards) 
and a base station mode all of which are Micaz.(The Crossbow Starter
Kit, Model:WSN-START2400CA)
I locally installed basestation application (XMeshBase_2420_hp) to the
mote connected to the pc (board interface Mib520) 
via Moteconfig and 
then switched to the remote program tab.
When I pressed the "Search" button, two remote motes were detected and
seen on the GUI. 
But, when I pressed the "Prepare" button; although I saw the message
"Node preparation may take up to 1 minute", the
process is never completed. 
What can be the reason of this problem, I exactly carried out the steps
described in MoteConfig User's manual.
I would be so glad if you help me about solution of this problem.

Murat Arslan
Middle East Technical University
Electrical and Electronics Eng. - Seni! or Student



________________________________

Get news, entertainment and everything you care about at Live.com. Check
it out! <http://www.live.com/getstarted.aspx%20> 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.millennium.berkeley.edu/pipermail/tinyos-help/attachments/20090217/4d67a587/attachment.htm