[Tinyos-help] R: Fwd: Need Help With TInyos2.0 in MTS400Sensorboard

[Denis Smorgon]

Hi  Ashwini,

I've your same problem and I contacted directly Xbow but they say that
schematics are not available because of Crossbow's Intellectual Property. 
Furthermore you have to pay attention because probably your mts400 could
mount different components from docs of Xbow. (i.e. my sensor board EEPROM
is different from that one points out on the documents and so on). 

So any designer/developer  should know about these problems of the Crossbow
products.

Denis

-----Messaggio originale-----
Da: tinyos-help-bounces at millennium.berkeley.edu
[mailto:tinyos-help-bounces at millennium.berkeley.edu] Per conto di Janos
Sallai
Inviato: martedì 26 maggio 2009 18.10
A: ashwini g; tinyos forum
Oggetto: Re: [Tinyos-help] Fwd: Need Help With TInyos2.0 in
MTS400Sensorboard

Ashwini,

As far as I know, there is no MTS400 driver for T2. The schematics is
not public, either. You can take a look at the MoteWorks sources to
see how the driver is implemented there. That helps a lot when you
want to figure out the pin numbers.

You can reuse the SHT11 driver in T2. However, the data and power
lines are not directly connected to the MCU, but through an I2C
switch. You would need to write the driver for that.

Janos

On Mon, May 25, 2009 at 1:44 AM, ashwini g <gashwini123 at gmail.com> wrote:
>
>
>
>
>
> Hi,
>
>
> I am using MTS400 sensorboard to read the temperature and humidity values
> for  mica2 tinyos2.x ,using SHT11... i hav a problem with the pin numbers
> i.e  for PDATA and SCK...
> for SHT11.. kindly help....
>
>
>
> Regards,
> Ashwini
>
> _______________________________________________
> Tinyos-help mailing list
> Tinyos-help at millennium.berkeley.edu
> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
>

_______________________________________________
Tinyos-help mailing list
Tinyos-help at millennium.berkeley.edu
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help